AlliedSignal KAP 140 Manuel d'installation télécharger pdf (Page 28)

BENDIX/KING

KAP 140

Page 2--8

Revision 6, Oct 2002

CS:00991I06.IDU

press the UP switch without pressing ARM and check for no trim response. Do the same with

the DN switch. NOTE: An active UP or DN switch without ARM will trip a latent switch failure

monitor after three seconds. For SW MOD 01/05 software or later, “PT” will be annunciated on

the KC 140 and MET operation will be disabled until all three MET switch inputs are inactive.

For earlier versions, “PT” will be annunciated on the KC 140 and MET operation will be disabled

until the fault is cleared and unit power is cycled.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 93 94

Pas de commentaire

AlliedSignal KAP 140 Manuel d'installation Page 28